Inspections

Inspections we offer:

Inspections we offer:

  • Buyer Inspections
  • Pre-Listing Inspections
  • New Construction Inspections
  • Multi-Unit Inspections
  • Townhouses and Condominiums
  • Beach House Inspections
  • Older Home Inspections
  • Manufactured Home Inspections
  • Annual Inspections
  • 11-Month Inspections
  • Specific Inspections (deck, roof, pilings, etc...)
  • Mold Inspections
  • Air Quality Inspections
  • Commercial Property Inspections
  • Drone Roof Inspections
  • Wood Destroying Insect Inspections


*Our Reports are an average of 30-50 pages in length.

*We work hard to ensure that within 24 hours of the inspection the client has the Home Inspection Report.

Included in an inspection:

Included in an inspection:

Grounds & Drainage - We inspect the grounds for proper grading away from the house, soil in contact with anything other than the foundation, vegetation in contact with or close to the structure that could damage the structure such as vines or tree branches in contact with the house or roof.

Foundation & Structure - We inspect the foundation walls, including the view from interior unfinished basements and crawlspaces. We report observed indications of cracking, settling, and active water infiltration. We look for shrinkage cracks, settling cracks, cracks caused by root or back-fill damage, step cracks and how they affect the level of the floor and interior door and window framing. We inspect structural components such as rafters, trusses, joists, sub-flooring, and framing. We inspect and report on any observed cutting and notching of framing members that may, in the inspector's opinion, present a structural compromise or safety concern.

Exterior - We inspect all utility meters and shutoffs for easy access. We inspect the siding, flashing, soffit, fascia, window frames, exterior doors, stairs/steps, and decks/balconies.

Roofing & Chimney - We thoroughly inspect the condition of the roof coverings, the gutters, the downspouts, the vents, flashings, skylights, chimney and other roof penetrations. We inspect fireplaces and chimney conditions. We inspect the general structure of the roof from the readily accessible panels, doors, or stairs.

Attic & Ventilation - We inspect the attic for access, insulation, roof sheathing condition, electrical, roof penetrations, and structural members. We check for proper and adequate ventilation through soffit, gable, roof, and ridge vents. We report on the general absence or lack of insulation and ventilation in the attic.

Crawlspace - We inspect the crawlspace for access, insulation, vapor barrier, plumbing, duct work, ventilation, and electrical components. We comment on water infiltration, inadequate structural supports, and overall condition of the space.

Interior - We inspect the walls, ceiling, floors, windows, and doors. We inspect for handrails at steps, cabinets, counter tops, and other storage areas. We report on signs of water leaking into the house. We inspect the garage including firewalls, mechanical door openers, and safety devices.

Appliances - We operate and inspect appliances that are present and deemed permanently installed by the inspector. This includes stove, oven, built in microwave, dishwasher, refrigerator, garbage disposal, and trash compactor. We report on overall condition and any defects, such as leaks, that are present.

Plumbing - We locate the main water shutoff. We inspect and run all accessible plumbing components such as water supply piping, manifolds, drain piping, sinks, drains, bath tubs, showers, and toilets; noting any leaks, low pressure, clogged drains, loose toilets, and supply piping that has a record of poor performance such as galvanized steel and polybutylene. We point out any visible fuel storage systems and sump pumps. We also inspect plumbing that is gas related including piping, shutoffs, and gas valves.

Water Heater - We inspect the water heater enclosure, heating system, exhaust piping, strapping, and relief valve piping. We report on the age of the appliance and overall condition, making note of excessive wear and leaking.

Electrical - We inspect the electrical line coming into the house, the main disconnect, and determine the rating of the service amperage. We inspect panels, breakers and fuses, the service grounding and bonding, all switches, receptacles, light fixtures, and GFCI receptacles. We report on any receptacles in which power is not present, polarity is incorrect, or if the receptacle is not grounded, is not secured to the wall, the cover is not in place, the ground fault circuit interrupter devices are not properly installed or do not operate properly, or evidence of arcing or excessive heat is present. We inspect the service entrance conductors and the condition of their sheathing. We report the absence of smoke detectors and carbon monoxide detectors and report the presence of solid conductor aluminum branch circuit wiring if readily visible.

Heating & Cooling - We inspect the heating system and describe the energy source and heating method using normal operating controls and report as in need of repair furnaces which do not operate. We inspect the central cooling equipment using normal operating controls and report on cooling systems that do not function as intended. We inspect the visible distribution methods for deficiencies and visible venting methods for improper or deficient installations. We report on the age of the appliances and overall condition.

Infrared Technology

Infrared Technology

Infrared Technology

Results with Modern Technology

345 Home Inspections includes infrared technology with every inspection, as part of our complete inspection service. We believe in going above and beyond the current standards to ensure or clients get the very best. Infrared technology is an advanced, non-invasive technology that allows the inspector to show clients things about their investment that can't be revealed using conventional inspection methods.

‚ÄčInfrared helps us identify and document possible moister intrusion.

‚ÄčIn terms of detecting moisture intrusion, an inspector using a thermographic camera can locate:

  • plumbing leaks;
  • hidden roof leaks before they cause serious damage;
  • missing, damaged and/or wet insulation; and
  • water and moisture intrusion around penetrations and at the foundation and building envelope that could lead to structural damage and mold.